Connection Of Transmission Signals (Lc51*/Ld512H); Terminal Block Connection For Lc51; Terminal Block Connection For Ld512H - Toshiba V Series User Manual

Chapter 2 Mounting, Dismounting and Connection
2.3

Connection of Transmission Signals (LC51*/LD512H)

2.3.1

Terminal block connection for LC51*

Connect the cable wires to the LC51* terminal block as shown below.
2
(1) Remove the terminal block cover from the rear panel of the unit and connect the wires of
(2) When wires are connected, reinstall the terminal block cover.
2.3.2

Terminal block connection for LD512H

Connect the cable wires to the terminal block of LD512H loop display unit as shown below.
(1) Remove the terminal block cover from the rear panel of the unit and connect the wires of
28
I/O bus cable and LD512H transmission cable.
Remove the terminal
block cover.
Figure 2-7 Transmission Cable Wiring
RS-485 cable.
RS-485 signal wires
RS-485 cable
Shield wire processing
I/O bus transmission signal wires
TB2
IO
IO
LD
LD
LD512H transmission
signal wires
TB1
TR
TR
Figure 2-8 RS-485 Cable Wiring
Model 1000 Loop Controller L1 LC511, 512 User's Manual
Transmission cable
Shield wires
Transmission cable
Remove the terminal
block cover.