Upload Reverse Generation - Toshiba V Series User Manual

1.6.4

Upload reverse generation

Necessary information can be uploaded from the controller to update the contents of the
Engineering Tool. In this case, it is necessary to download necessary source information for
tool indication (hereafter described the tool source) to the LC51* beforehand.
When the tool source is downloaded to the LC51* by the Engineering Tool, the downloaded
data will be stored to the code memory section of the LC51*. Therefore, to execute upload
reverse generation (downloading the tool source), enough memory space is required in the
code memory.
Though necessary memory space differs depending on how to create programs and the
amount of comments, 80% or more of empty space is needed in the memory as a guideline
value.
For operation concerning upload reverse generation and tool source download, see
"Engineering Tool 2 User's Manual (Basic Part) 6F8C0022."
Supplementary explanation
Upload reverse generation conforms to the following versions:
Engineering Tool 2 V2.7.1 or higher
LC51* V2.30 or higher
6F8C1135
1.6 Storing User Data
1
9