Toshiba V Series User Manual page 97

(3) In the same way as above, register necessary data for LP_DATA side.
4.4.3 I/O variables registration
I/O configuration differs depending on the system used, variables to be used for I/O are not
provided as standard. Variables actually required shall be registered. In this example, all
points of the LC511 (built-in SLP03) shall be registered. For how to obtain the data
configuration and Word No. of I/O module, see E.4 "I/O Variable (SIO1)."
Variable name Data type
ADE BOOL
DI1 BOOL
DI1 BOOL
DI1 BOOL
RM BOOL
AI1 INT
AI2 INT
AI3 INT
AI4 INT
DO1 BOOL
DO2 BOOL
DO3 BOOL
MV INT
AO1 INT
AO2 INT
6F8C1135
Figure 4-12
Table 4-8 I/O Variables
Word No. Bit No.
4 8 Built-in SLP03 ADC error
6 0
6 1
6 2
6 15 (In the case of SLP04, R/M input)
7 0
8 0
9 0
10 0
518 0 When manual operation is required, use Tag
(PB1.FO1).
518 1 When manual operation is required, use Tag
(PB2.FO1).
518 2 When manual operation is required, use Tag
(PB3.FO1).
519 0 When manual operation is required, use Tag (LPn.MV).
520 0 When manual operation is required, use Tag (LPn.MV).
521 0 When manual operation is required, use Tag (LPn.MV).
4.4 Variables registration
Note
4
75