Toshiba V Series User Manual page 158

Appendix B Details of Display Panel
Display mode switching
MV/SV key
ON
Normal
Fast ON
B
Alarm
Operation
Fast operation
Select branching ON
Display select
Loop select
Note: All decimal points blink (Numeric display and Numeric display + Decimal points all lit are repeated)
(1) Display mode
(2) Multiple loop display
136
Operational
mode
MV/SV key OFF
Normal mode
F/S key
ON
F/S key
2
ON
F/S key
1
ON
Loop Numeric
Mode
display display
ON ON
ON ON
ON ON
ON ON
ON ON
ON
ON ON
ON ON
(Note)
Figure B-1 Status Change Diagram in the Display Mode
Only 1 loop is displayed always and the displayed loop can be changed by key operation.
For the initial setting for this display loop, LD512H is determined by the address switch.
For the LC51*, the address is "0".
The same multiple loops can be displayed but they cannot be operated.
F/S key ON
F/S key OFF
MV/SV key
ON
F/S key OFF
FAST ON mode
F/S key
OFF
Selection
branching mode
F/S key ON for longer than
F/S key OFF
Display
MV key/PV/SV/MV switching
selection mode
SV key
Loop selection
MV key loop switching
mode
Manual Mode
SELLED
operation operation
OFF Enabled Enabled
OFF Enabled Enabled
OFF Enabled Enabled
OFF Operating Enabled
OFF Operating Enabled
OFF Enabled Enabled
OFF Disabled M only
enabled
OFF Disabled M only
enabled
Model 1000 Loop Controller L1 LC511, ,512 User's Manual
Fast operation
mode
MV/SV key
MV/SV key
OFF
ON
Alarm mode
Bar graph Alarm check
Normal Not executed
Normal Not executed
PH/PL Executed
display
Normal Not executed
Normal Not executed
Normal Not executed
Normal Not executed
Normal Not executed