2.2
Mounting and Removing the Unit
The controller consists of the main unit and a case/cable assembly to store the main unit.
The LC51* shall be mounted by the attached fixture.
2.2.1
Mounting and removing
Mounting
(1) Insert the case from the front side. Install a clamp on the top and the bottom surfaces of
the case and rotate the rod to fasten the case to the panel. Be careful not to tighten too
much.
Removing
(1) Remove the case in reverse order of mounting the case.
6F8C1135
Rod
Clamp
Mounting panel front view
‡
A
Figure 2-2 Mounting and Removing the Case
2.2 Mounting and Removing Terminal Block Unit
2
25