Chapter 1 Overview
1
18
I/O section alarm indicator (red)
Indicator
Unlit
Normal operation
• ADC error
Blinks
• MV read-back error
Lit
Initialization in progress
Station address rotary switch
Name
TOSLINE-S20LP address setting (1 − 64)
H/L
Engineering selection switch
Table 1-9 Engineering Selection Switch
Switch name and function
1 Download setting switch
2 Internal memory clear
3 Test program mode
4 Tool selection
(Set ENG switches 5 − 8 to OFF.)
Battery
This battery is used to store internal information at the time of power failure.
Type CR2025 (lithium battery)
Stopper 1
To use the side display or keyboard, extract it while pushing up this stopper.
Stopper 2
In the case of unit replacement, extract the unit while pushing this stopper. To restore the
unit, push this stopper also to restore the unit.
Side keyboard
This keyboard is used to enter data. See Chapter 6, "Side Key and Display."
Side display
This display shows information and data (16 characters, 2 digits).
Mounting fixture
This fixture is used to fasten the main unit to the panel where a prescribed square hole is
fabricated. One set of upper and lower sections
Status
Setting contents
Switch status
ON
Download
OFF
Normal setting
ON
Execute memory clear
OFF
Normal setting
ON
Test program mode
OFF
Normal setting
ON
S-SL loader connection
OFF Normal setting
Model 1000 Loop Controller L1 LC511, 512 User's Manual