Chapter 2 Mounting, Dismounting and Connection
2.4
Cable Connection to Engineering Tool 2 (LC51*)
Connect the LC51* and the Engineering Tool 2 using a dedicated RS-232C cable.
2
• Do not bend the hook of the modular connector to opposite direction.
• When you remove the cable, do not pull out the cable by holding its cable. Make sure
• Wiring may be broken if handled carelessly.
• Connection
Check the orientation of the modular connector and push it until a click sound is heard.
• Removing
Pull out the modular connector while pushing the hook of the connector.
30
to hold the connector to pull it out.
Caution
Model 1000 Loop Controller L1 LC511, 512 User's Manual