Table of Contents
Advertisement
Figure 23. Removing the drive backplane cable
NOTE:
If your system supports a SAS/PCIe backplane, then you must also loosen two additional retention screws that
connect the storage controller cable connector to the system board connector.
5
Lift the backplane away from the system.
Next step
Install the drive
backplane.
Installing the drive backplane
Prerequisite
Follow the safety guidelines listed in
Steps
1
Align the retention screws on the drive backplane cable connector with the screw holes on the system board connector.
2
Using the Phillips #2 screwdriver, tighten the retention screws to secure the drive backplane cable connector to the system board.
64
Installing and removing system components
Safety
instructions.
Advertisement
Table of Contents
