CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
1. Press the release button.
2. Slide the drive blank out of the drive slot.
Figure 21. Removing a drive blank
Next steps
1.
Replace the Drive or a drive
NOTE:
The procedure to install a drive blank is similar to a drive installation.
Installing the drive blank
Prerequisites
1. Follow the safety guidelines listed in
2.
Remove the front
bezel.
CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
1. Insert the drive blank into the drive slot.
2. Push the blank until the release button clicks into place.
Figure 22. Installing the drive blank
Next steps
1.
Replace the front
bezel.
48
Installing and removing system components
blank.
Safety
instructions.