Table of Contents
Advertisement
CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Press the release button, and slide the drive blank out of the drive slot.
Figure 56. Removing a drive blank
Next steps
1.
Install a drive
or a
drive blank
Installing a drive blank
The procedure for installing 2.5 inch and 3.5 inch drive blanks is identical.
Prerequisites
Follow the safety guidelines listed in
CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 57. Installing a drive blank
Next steps
If removed,
install the front
Safety
instructions.
bezel.
Installing and removing system components
105
Advertisement
Table of Contents
