Hard Drive Replacement Overview; Hard Drives; Identify A Faulted Hard Drive - Dell EMC IDPA DP4400 Service Procedures

________________________________________________________________________________________
___
| ID| Status| Redundancy| Model
Version|
|
========================================================================================
==|
| 1 | OK | Full
53 | *
| 2 | OK | Full
53 |

Hard drive replacement overview

Hard drives

Identify a faulted hard drive

Status LED indicators
| PWR SPLY,750W,RDNT,ARTESYN| 0PJMDNA01| PHARP0079201AX| 00.1B.
| PWR SPLY,750W,RDNT,ARTESYN| 0PJMDNA01| PHARP0079201AZ| 00.1B.
2. Verify that the status for both power supplies is "OK".
Hard drives are supplied in hot swappable hard drive carriers that fit in the hard drive
slots.
CAUTION
Before attempting to remove or install a hard drive while the system is running,
see the documentation for the storage controller card to ensure that the host
adapter is configured correctly.
CAUTION
Do not turn off or restart your system while a hard drive is being formatted.
Doing so can cause a hard drive failure.
When you format a hard drive, allow enough time for the formatting to complete. Be
aware that high-capacity hard drives can take a long time to format.
Use the following information to identify a faulted hard drive:
l
At the front of the system, check the left control panel Drive indicator
described in Status LED indicators
On the hard drive, check the status indicator as described in
l
codes on page 18
Note
The status LED indicators are always off and only turn on to a solid amber if any error
occurs.
Remove and replace assemblies
| Part# | Serial#
on page 12.

Hard drive replacement overview

| FW
as
Hard drive indicator
17