Leuze electronic AMS 348i Manual page 78

PROFINET interface
9.9.3.21 Module 6: Status and control
PROFINET module identifier
Module-ID
Submodule-ID
Description
The module signals various status information of the AMS 348i. The laser can be controlled
via the master's output data.
Parameters
None
Input data
Input data Description
a
Laser 
Signals the laser status.
status
b
Preset 
Status of the preset value.
status
This bit toggles on each teach event of a
c
preset value.
Preset teach
d
Reserved
If the intensity of the received signal is
e
less than the warning threshold, the
Intensity
status bit is set.
(ATT)
f
If the internal device temperature
exceeds or drops below the set limit
Temperature
value, the status bit is set.
(TMP)
g
Laser prefailure message.
Laser (LSR)
h
If implausible measurement values are
Plausibility
diagnosed, the status bit is set.
(PLB)
i
If a hardware error is diagnosed, the
Hardware
status bit is set.
(ERR)
j
Signals that the value is less than lower
Lower
position limit limit value 1.
value 1
k
Signals that the value is greater than
Upper
upper limit value 1.
position limit
value 1
75
1006
1
Rel. Data Value
addr. type
0: Laser ON
1.0 Bit
1: Laser OFF
0: Preset not active
1.1 Bit
1: Preset active
1.2 Bit 0 or 1
1.3 Bit
0: OK
1.4 Bit
1: Warning
0: OK
1.5 Bit
1: Temperature above/below
0: OK
1.6 Bit
1: Laser warning
0: OK
1.7 Bit
1: Implausible measurement
0: OK
0.0 Bit
1: Hardware error
0: OK
0.4 Bit
1: Value less than limit
0: OK
0.5 Bit
1: Value greater than limit
AMS 348i
Default
–
–
–
–
–
–
limit
–
–
value
–
–
–
Unit CR to
module
metr. Inch
– –
– –
– –
– –
– –
– –
– –
– –
– –
– –
– –
Leuze electronic