Leuze electronic AMS 348i Manual page 52

Display and control panel AMS 348i
Parameter enabling
o
Viewing and editing parameters
As long as parameter enabling is activated, the entire AMS
As long as parameter enabling is activated, communication between control and AMS
is interrupted. The continued networking via BUS OUT is retained.
Attention!
The AMS 348i
display. The device is reactivated on the PROFINET after parameter enabling is exited.
Notice!
In the PROFINET
PROFINET Controller.
Parameters set via the display when operating the AMS
overwritten by the parameters set in the GSD modules. For GSD modules not used actively
on the PROFINET, the default settings of the AMS apply, see "Overview of the GSD modules"
on page 64. All parameters are thus preset by the PROFINET.
Notice!
If a password was stored, parameter enabling is not possible until this password is entered,
see "Password for parameter enabling" below.
Password for parameter enabling
Notice!
The master password 2301 can enable the AMS
49
OFF
ON
ESC ESC
is deactivated on the PROFINET if parameter enabling is activated via the
network,
Press the enter button to switch on parameter
enabling.
The PWR LED illuminates orange; the display is
inverted. You can now set the individual parameters
on the display.
Press the ESC button twice to return to the
Parameter menu.
configuration is performed
348i at any time.
AMS 348i
348i display is inverted.
exclusively
348i on the PROFINET are
Leuze electronic
348i
via the