Leuze electronic AMS 348i Manual page 62

PROFINET interface
9.8.4.10 Step 4 – Transfer of the configuration to the IO Controller (S7 PLC)
After the correct transfer to the IO Controller (S7 PLC), the PLC automatically carries out
the following activities:
• Check device names
• Assignment of the IP addresses that were configured in the HW Config to the
IO devices
• Establishment of a connection between the IO Controller and configured IO devices
• Cyclical data exchange
Notice!
Participants without assigned device names cannot yet be addressed at this point in time!
9.8.4.11 Step 5 – Configuration of the device name - naming the device
Each AMS
plate of the device.
Figure 9.12: MAC ID on the name plate
Notice!
This figure is for illustration only and does not correspond in all details to the AMS 348i. The
MAC ID in particular must be read separately from each individual device. The MAC ID is
also shown in the display of the AMS 348i.
Network information
IP Address:
Netzmask:
Gateway:
MAC ID:
DevName:
59
348i has an individual and unique MAC ID. The MAC ID can be found on the name
---.---.---.---
---.---.---.---
---.---.---.---
--.--.--.--.--.--
-------------------------
After successful naming, the device name can be read here under DEVName.
AMS 348i Leuze electronic