Remove A Daughter Card - NETGEAR M6100 Hardware Installation Manual

Remove a Daughter Card


To remove a PoE card:
Remove the switch blade from the M6100 chassis switch.
1.
For more information about removing switch blades, see
on page 45.
Blade
Loosen the spring-loaded captive retaining screws on the PoE card until they pop up.
2.
If the retaining screws are too tight to loosen by hand, use a 3/8-inch flat-blade
screwdriver.
At each end of the card, grasp the top and bottom edges and carefully lift the card to
3.
disengage the connectors.
Place the PoE card on an ESD-preventive work surface or into antistatic packaging.
4.
If you are replacing the PoE card, install the replacement card.
5.
For more information about installing daughter cards, see
page 50.
Re-install the switch blade.
6.
For more information about installing switch blades, see
on page 42.
Blade
NETGEAR M6100 Switch Chassis
Install or Remove Daughter Cards
51
Remove an M6100 Switch
Install a Daughter Card
Install an M6100 Series Switch
on