Parking Brake; Emergency Stop (If Configured In Infoviewt) - New Holland CX720 Operator's Manual

PARKING BRAKE

The parking brake is operated by pressing tumbler
switch 1.
The parking brake has two positions.
• The first position: Off position
NOTE: When selecting another gear, the parking
brake is activated automatically during shifting.
• The second position: Parking position
NOTE: Each time the engine is started, the parking
brake will be activated. (even if the parking brake
tumbler switch is set in the "OFF" position) To release
the parking brake, set the parking brake tumbler
switch first in the "ON" position after in the "OFF"
position.
NOTE: When the "ON" (parking) position is selected
during driving, the parking brake will be activated
when the multifunction handle (hydrostatic) is moved
to neutral position or the ground speed is lower than
0.5 km/h (0.3 mph).
Emergency stop (If configured in InfoViewt )
Pressing quick stop button 2 on the multifunction
handle while driving the combine will cause the
combine to stop.
Depending on the time button 2 is pressed, the
combine will stop like explained below:
• If pressing not longer than two seconds on
quick stop button 2:
The hydrostatic will be disabled immediately.
If pressing between two and six seconds on
•
quick stop button 2:
The hydrostatic will be disabled immediately.
After two seconds the parking brake will
come on additional, during four seconds.
• If pressing for a minimum of six seconds on
quick stop button 2:
The same result will occur when pressing
between two and six seconds, but after six
seconds the parking brake will close
completely to stop the combine abruptly.
Remark: After an emergency stop, to advance again,
bring first the multifunction handle back to the neutral
position (the parking will be released automatically).
3–4
SECTION 3 – FIELD AND SITE OPERATION
1
2