New Holland CX720 Operator's Manual page 219

SECTION 2 – CONTROLS, INSTRUMENTS AND OPERATION
Header usage
•
If the full header width is not used during harvesting,
a header width correction has to be made to obtain a
correct area counting.
Proceed as follows:
1. Select the item "Header Usage" in the header
sub-menu.
2. Change the "usage", using the "+" and/or "–"
keys.
3. Press "Enter" to store the new value.
NOTE: The value can only be changed in steps of
1m (Metric) or 1 ft (Imperial).
Remark: It is possible to make the header usage
value visible on the main work screen as you will use
this screen most of the time while harvesting.
Header width
•
When another header is attached to the combine, it
is necessary to recalibrate the header width to obtain
a correct area counting.
Proceed as follows:
1. Select the item "Header width".
2. Use the "+" or "–" buttons to change the header
width.
3. Press "enter" to store.
NOTE: The value can only be changed in steps of
0.1m.
• Rows in use
In case a corn header is attached to the combine and
to obtain a correct hectare counting, the number of
rows that are used can be adjusted.
Proceed as follows:
1. Select the item "Rows in use".
2. Change the value, using the "+" and/or "–" keys.
NOTE: The value can be changed from 24 down to
0.
3. Press "Enter" to store the new value.
Remark: It is possible to make the "Rows in use"
value visible on the main work screen as you will use
this screen most of the time while harvesting.
2–146
261
262
263