Starting The Engine; Daily Start-Up Procedure - New Holland CX720 Operator's Manual

STARTING THE ENGINE

Ensure you are thoroughly familiar with the
instruments and controls before starting the engine
for the first time.
To start the engine safely, follow the points as outlined
below.
CAUTION
Before starting the engine, ensure there is enough
ventilation and everyone is standing clear of the
combine.

Daily Start-up procedure

Proceed as follows:
1. Carry out the routine engine service, i.e. check
coolant, oil and fuel tank levels (refer to
"SECTION 4
MAINTENANCE"). Ensure the battery key is in
the "ON" position.
2. Make sure the Multi function handle is in neutral
position.
3. Ensure the road-field mode tumbler switch is in
the road position and the parking brake switch is
in the ON position.
4. Check that the both brake pedals are coupled
together.
5. Ensure the gearshift selector switch is in the
neutral position.
3–2
SECTION 3 – FIELD AND SITE OPERATION
– LUBRICATION
6. Insert the ignition key into the ignition-and-stop
switch and turn the ignition key in the "contact"
position, check for any alarm or fault messages
on the InfoViewt monitor.
7. Before starting the engine, warn bystanders by
sounding the horn several times.
AND
8. Start the engine when Pre-Heat lamp below
Ignition key starts to flash. Turn the ignition key
clockwise to engage the starter motor. Engine
wills starts at low idle automatically. (If the engine
fails to start after 20 seconds, release the ignition
key for about 1 minute before re-engaging the
starter motor).
9. As soon as the engine starts, release the ignition
key.
10. Check for any engine Alarm/fault messages.
IMPORTANT: Allow the engine to run for one minute
at low idle before moving off, to ensure adequate
lubrication of the turbocharger bearings.