SECTION 2 – CONTROLS, INSTRUMENTS AND OPERATION
Current settings
1. Select the Automatic Crop Settings screen 1 in
the menu bar.
2. Select the current settings sub-menu 2.
3. The current settings screens allow the operator to
monitor and save machine settings while
threshing.
4. The following settings are controlled as current
settings:
•
Cleaning fan RPM
•
Thresher RPM
•
Concave clearance
•
Auto reel speed offset
Additional equipment (if installed)
•
Upper sieve opening
•
Lower sieve opening
Reel horizontal position
•
Reel verical position
•
5. The current machine settings 1 and the stored
settings 2 for the current crop and ACS mode are
displayed in two columns. If the two columns are
not identical, the icon will be highlighted. All items
on this page are read only. The operator can only
change the current settings via the switches on
the right-hand module or multifunction handle.
6. To save the current machine settings, press
Enter, to open the Save Current Settings pop-up.
The "Confirm" option will be highlighted. To save
the settings to the current crop and ACS mode,
press "enter" again. It is only necessary to use the
drop down menus if the operator wants to save
the settings for a different crop or ACS mode.
2–90
20040173
148
149
150