SECTION 1 – GENERAL INFORMATION AND SAFETY
ADJUSTMENT OF THE SIDE LIGHTS
(IF INSTALLED)
The side lights (1) has to be adjusted to the maximum
width of the combine for road transport.
At the front:
To adjust, proceed as follows:
1. Loosen the nut (2) and the bolts (3) on both sides.
2. Slide the support with the side light (1) in or out
and adjust it to +/– 150 mm (5 - 29/32") less than
the maximum width of the traction tyres.
3. After adjusting, tighten the bolts (3) and the nuts
(2) on both sides.
NOTE: Be sure that the side lights are installed
symmetric in relation to the middle of the combine.
At the rear:
A kit is available to install extensions to the rear light
arms, if required.
1–46
53
54
55