Steering Cylinder Adjustment - New Holland CX720 Operator's Manual

6. Steering cylinder adjustment

To adjust the steering cylinders, proceed as follows:
1. After adjusting the toe-in, adjust distance "X" of
the both cylinders. (Distance "X" = centre to
centre balljoint of the cylinder completely
retracted) see table.
Height position Height position
1
2 3 4
In case a cylinder for SmartSteert system is
installed
Height position Height position
1
2 3 4
IMPORTANT: Check if:
Distance "Y" maximum = 120 mm (4 - 3/4")
Distance "Z" minimum
– (H.D.A.S.A) = 50 mm (1- 31/32")
– (P.R.A) = 70 mm (2 - 3/4")
Distance "Z" maximum = 80 mm (3 - 1/8")
2. After adjustment, tighten the nut 1 with a torque
between 190 and 210 Nm (140 and 155 ft.lbs) and
the nut 2 with a torque between 290 and 310 Nm.
(214 and 229 ft.lbs.)
4–106
SECTION 4 – LUBRICATION AND MAINTENANCE
P.R.A.
X (mm) X (inches)
759 29–14/16"
753 29–5/8"
X (mm)
769
763
H.D.A.S.A.
X (mm) X (inches)
728 28–21/32"
722 28–1/2"
P.R.A.
X (inches)
30–1/4"
30
FIXED
X (mm) X (inches)
752 752 29–5/8" 29 5/8"
H.D.A.S.A.
X (mm) X (inches)
738 29–1/16"
732 28–13/16"
206
207