New Holland CX720 Operator's Manual page 4

GENERAL
This manual has been prepared to assist you in the correct procedure for running in, driving, operating, adjusting
and maintaining your new machine.
This machine has been designed and built to give maximum performance, economy and ease of operation under
a wide variety of crops and conditions.
Prior to delivery, your machine was carefully inspected both at the factory and by your dealer to ensure that it
reaches you in optimum condition. To maintain this condition and ensure trouble-free operation it is important
that routine services, as specified in this manual, are carried out at the recommended intervals.
Before attempting to drive or operate your machine, read this manual carefully (especially the chapter covering
the Safety Precautions) and keep it in a convenient place for future reference.
''Left" and ''right" used throughout this manual are determined from the rear, facing in the direction of travel of
the machine during operation.
If at any time you require advice concerning your machine, do not hesitate to contact your authorised dealer.
He has factory-trained personnel, genuine service parts and the necessary equipment to carry out your service
requirements.
IMPORTANT:
This machine has been designed and built according to the European Directive 98/37/EC.
Always use genuine New Holland Service parts or parts matching at least the same quality, reliability and
functionality as the equivalent original Service Parts when servicing and repairing your machine and do not
modify your machine without a written permission of the manufacturer. Failure to do so will void the responsibility
of the manufacturer.
An EC Declaration of Confirmity is separately delivered with your machine.
Store this EC Declaration into the storage space for your Operator's Manual
(refer to section 2 – Controls, Instruments and Operation).
The maximum road speed of your machine is limited electronically. Do not try to change it.
Check local road legislation before driving the machine on public roads.
When operating interchangeable New Holland built equipment, ensure the equipment is CE approved.
As this publication is distributed throughout our international network, the equipment illustrated, either as
standard or as an accessory, may vary according to the country in which the equipment is to be used. Low cost
configurations, as chosen by the customer, may deviate from the specifications given.
Several figures in this manual show the safety guarding or the additional guards, legally required by certain
countries, open or removed to illustrate better a particular feature or adjustment. The machine must not be used
in this condition. For your own safety, ensure that all guards are closed or replaced before operating the machine.