New Holland CX720 Operator's Manual page 442

4. Sensor plate 1 is now visible and can be cleaned
if necessary.
CAUTION
Do not use a screwdriver or any other sharp device
to avoid scratches on the sensor plate.
5. Close the sensor and secure with the fast coupler.
6. Reinstall the cover.
To calibrate the grain flow sensor, refer to
"SECTION 2 – "CONTROLS, INSTRUMENTS AND
OPERATION".
To adjust the sensor plate 1 (fig. 186), proceed as
follows:
1. The sensor plate 1 is adjusted correctly, if it is
possible to insert a rod into hole 3.
2. If not, adjust the plate by adjusting the two
supports 4 in combination with the fast coupler 2.
SECTION 4 – LUBRICATION AND MAINTENANCE
186
187
4–77