SECTION 2 – CONTROLS, INSTRUMENTS AND OPERATION
7. Go to screen (2) (fig. 131), using the right and
down navigation keys.
NOTE: The direction (arrow) of the new screen
compared to the screen before gives the direction of
the navigation key to use.
8. Select the "DGPS mode" screen (2) (fig. 131) by
using the right navigation key. Using the up and
down navigation keys gives the possibility to
select the mode.
•
DGPS Only
•
DGPS Manual Off
•
DGPS Auto On/Off
9. Press "enter" to confirms the selection.
10. Select the "DGPS source" screen (3) (fig. 131)
by using the right navigation key. Using the up
and down navigation keys gives the possibility to
select the source.
•
Omnistar
•
Beacon Only
•
WAAS/ EGNOS Only
•
Auto
11. Press "enter" to confirms the selection.
12. Select the screen (4) (fig. 131) by using the right
navigation key. Using the up and down navigation
keys gives the possibility to select the status of
the satellite.
NOTE: The table below shows the status for each
satellite that needs to be selected.
(The satellite will be visible as name or number)
Satellite
AORE (120)
ARTE (124)
IORW (126)
IOR (131)
Others
13. Press "enter" to confirm the selection.
2–80
Status
Ignore Hlth
Ignore Hlth
Ignore Hlth
Disabled
Disabled