New Holland CX720 Operator's Manual page 275

Switching edges:
NOTE: Except for crop edge calibration, the HGS will
not automatically switch or detect a left or right crop
edge.
NOTE: Switching of the crop edge can only be done
manually and only when the SmartSteert
is in it's enabled position.
1. To switch, press and hold the neutral unlock
switch (1) and at the same time press and hold
the header lateral float rocker switch (2) for
minimum two seconds.
Left for left-hand side crop edge and right for
right-hand side crop edge.
2. A sound signal indicates that the switching has
been done.
3. The HGS sensor turns now to the left-hand or the
right-hand side to focus on the selected crop
edge.
Offset adjustment
It is also possible to fine-tune the distance between
the crop edge and the header side. The adjustment
can only be done when the SmartSteert system is
in it's operating mode.
1. To switch, press and hold the neutral unlock
switch (1) and at the same time press the header
lateral flotation rocker switch (2) shortly.
Left for left-hand side fine adjustment and right for
right-hand side fine adjustment.
2. Each pulse will adjust the offset with 10 cm (4") to
the left or to the right and the newly selected offset
will be saved automatically.
NOTE: The offsets are reset automatically each time
the crop edge calibration is done.
3–32
SECTION 3 – FIELD AND SITE OPERATION
system
26
27