New Holland CX720 Operator's Manual page 332

Baffle plate
The baffle plate (1) can be set in two positions:
• The front position (3) retains material longer and
give a fine chop.
• The rear position (4) gives a slightly longer chop,
but reduces power consumption and knife wear.
To change the position of the baffle plate (1), proceed
as follows:
On both sides:
1. Loosen the bolt (2) and remove the bolt (3).
2. Install the bolt (3) in position (4) and tighten the
bolts.
SECTION 3 – FIELD AND SITE OPERATION
171
3–89