Combine Info Screen - New Holland CX720 Operator's Manual

SECTION 2 – CONTROLS, INSTRUMENTS AND OPERATION
VI COMBINE INFO SCREEN
Switch to the combine information screen as follows:
1. Select the combine info menu in the menu bar by
using the up and down navigation keys.
2. A sub-menu will appear next to the menu bar.
3. To enter that sub-menu, press the "right"
navigation key.
4. Run through the sub-menu by using the up and
down navigation keys:
The "up" key to select a screen up the ladder.
The "down" key to select a screen down the
ladder.
Keeping the "up" and "down" navigation key
depressed will shift the menu quickly up or down.
The selected symbol always remains in the
middle of the menu bar and blinks to show the
selected position. When the navigation keys are
not used for a while, the selected symbol will stop
blinking and will be inverted until the navigation
keys are used again.
The different sub-menus in the combine information
menu are shown in figure 152 and will always appear
in that sequence.
1. Engine
2. Electrical
3. Hydraulics
4. Driveline
5. Header
6. Straw elevator
7. Threshing
8. Cleaning
9. Clean grain/unload
10. Residue
11. RPM info
12. Data logger info (if installed)
13. GPS info (if installed)
14. Loss info
In these sub menus information can be found in
relation to the selected sub menu.
151
152
2–91