Ordering Parts And/Or Accessories - New Holland CX720 Operator's Manual

11. Clean all belts, then check belt tension.
Adjust if necessary.
12. Reinstall the straw elevator.
13. Clean the air filter element.
14. Use compressed air, or water under pressure, to
clean out the engine radiator. Use a low-pressure
water jet, or compressed air, to clean the
air-conditioner condenser fins.
15. Check the anti-freeze content in the engine
cooling system.
16. Fill the fuel tank completely.
17. Store the combine in a dry place, protected from
the weather.
18. Close off all engine openings with plugs or
greaseproof paper.
19. Support the combine on wooden blocks to relieve
the weight from the tyres. Leave tyres inflated.
20. Disconnect the battery cables. Clean and charge
the batteries in situ.
IMPORTANT: The batteries should be charged every
8 to 10 weeks with a 5 to 6 amperes current for a
period of 24 hours to a minimum of 12.6 volt.
NOTE: Removing the batteries will not harm the
storage of information in the InfoViewt monitor.
21. Straw chopper: Remove all knives and bushings,
grease them thoroughly and reinstall them onto
the rotor.
22. Every 4 weeks, remove the engine opening
seals, start the engine and run at 3/4 throttle for
1 to 2 hours. Move all the variators from minimum
to maximum, and vice versa, to ensure adequate
lubrication to prevent rust.
6–2
SECTION 6 – VEHICLE STORAGE
23. Switch on the air conditioning while the engine is
running, only if the ambient temperature is above
15°C (60°F) minimum.
lubrication of the compressor parts. Operate the
air-conditioning system for at least 15 minutes.
24. Reinstall the engine opening seals.
Periodic checks will help to keep your combine
maintenance and repairs to a minimum and avoid
costly breakdowns
Therefore, it is good practice to have the
combine inspected at the end of the season. Your
NEW HOLLAND dealer will gladly quote a price
for this work.
ORDERING PARTS AND/OR
ACCESSORIES
When preparing the combine for storage, check
thoroughly for any parts that may have become worn
and need replacing.
Parts and/or Accessories should be ordered at once
and fitted before the next harvesting season.
When ordering Parts and/or Accessories, always
ensure to give your NEW HOLLAND dealer the model
number and serial number of your combine. See the
chapter headed ''Product Identification''.
INSIST ON GENUINE NEW HOLLAND ''QUALITY''
PARTS AS THEY
PERFORMANCE AND ARE COVERED BY OUR
WARRANTY.
FOR BEST PERFORMANCE YOUR COMBINE
SHOULD BE SERVICED BY AN AUTHORISED
NEW HOLLAND DEALER.
This will ensure
during the season.
WILL GIVE THE BEST