New Holland CX720 Operator's Manual page 142

SECTION 2 – CONTROLS, INSTRUMENTS AND OPERATION
To identify an area in the field with a marker, press the
number assigned to that marker on the alphanumeric
keypad. The number pressed is shown in the
indicator bar near the "data card installed" symbol at
"1".
NOTE: Pressing a number (1 to 6) to identify markers
can be done when "Road info", "Main info", "Custom
info" or "Harvest info" menu or sub-menu is selected.
If another menu is selected by pressing a number, the
"Main info" menu will blinking.
Pushing again the number on the alphanumeric
keypad will cause the marking to stop. The number
shown in the indicator bar will disappear from the
screen.
NOTE: It is possible to enter more than one number
at the same time, if more than one marker needs to
be set at the same time in the field during harvesting.
NOTE: If you want to set a marker during harvesting
and you don't remember the assignments, proceed
as follows:
1. Select "Road Info", "Main info, or Custom info"
menu and press "enter".
2. Pop-up screen (1) will appear.
3. Select "Markers listing", using "up" navigation key
and press "enter".
or
Press number "0" on the alphanumeric keypad
when any menu is selected.
107
108
2–69