New Holland CX720 Operator's Manual page 208

SECTION 2 – CONTROLS, INSTRUMENTS AND OPERATION
Calibration of the HGS Turntable sensor
1. Turn the steering wheel slightly so that the sensor
in the steering column recognises the steering
wheel.
2. Activate the SmartSteert system by pressing
and holding the SmartSteert rocker switch for a
minimum of two seconds.
3. The SmartSteert icon will appear greyed out in
the upper left corner of the InfoViewt monitor.
4. Select the calibration sub-menu and press the
"right" navigation key to enter the information box.
5. Select item "HGS Turntable sensor", using the
navigation key and press "enter".
Message: "Refer to manual for more information"
Message: "Then press ENTER"
6. Press "enter" to continue or "esc" to abort the
calibration.
Message: "Calibration initiated"
7. The SmartSteert sensor will now search and
determine the position of the crop edge, left-hand
side or right-hand side of the header.
239
240
241
2–135