Container Change With The Preset [Acknowledge Auto.] - Ecolab EcoAdd Series Operating Instructions Manual

9.4.1

Container change with the preset [acknowledge auto.]

Fig. 85: Container change for the preset (acknowledge auto.)
1. If the metering pump detects an empty container via a connected suction pipe with
integrated empty signal detection, this is displayed in red via the empty signal
symbol
ð The pump adjusts the operation.
2. Changing a container:
- Remove the suction pipe from the empty container.
- Replace the empty container with a full one.
- Put the suction pipe back into the full container.
ð The pump detects the new fill level via the connected suction pipe.
3. Following a detected container change, the pump automatically resumes operation
with the last settings.
1
.
If the container size has been set as described in
7.10.13 'Container size' on page 118, for pumps WITHOUT a
Bluetooth PCB a canister
instead of the empty signal symbol.
DANGER!
It is essential that the personal protective equipment (PPE) described
on the product data sheet (safety data sheet) for the metering medium
is used.
WARNING!
Risk of slipping due to fluid in the operation and provisioning
area!
– Wear non-slip, chemically resistant shoes when working.
– Place product containers in a tank to prevent a slipping hazard
caused by leaking fluids.
ENVIRONMENT!
Immediately soak up any leaking liquids with a suitable binding agent
and dispose of properly.
2
is displayed as the empty signal symbol
143
Operation
3
Ä Chapter
417102276 Rev. 5-02.2020