Container Change With The Preset - Ecolab EcoAdd Series Operating Instructions Manual

Operation
9.4.2 Container change with the preset [acknowledge man.[
Fig. 86: Empty signal: Changing a container
1. Press the 'empty signal display'
2. If a password prompt is displayed, the access code must be entered (
7.7.2 'Open the main menu with the access code activated' on page 74).
ð The screen switches to the information screen for the 'Empty signal' .
3. Changing a container:
- Remove the suction pipe from the empty container.
- Replace the empty container with a full one.
- Put the suction pipe back into the full container.
ð The pump detects the new fill level via the connected suction pipe.
4. Following a detected container change, the pump automatically resumes operation
with the last settings.
417102276 Rev. 5-02.2020
1
To enter the setting, press the displayed empty signal 'for approx.' 3
seconds.
DANGER!
It is essential that the personal protective equipment (PPE) described
on the product data sheet (safety data sheet) for the metering medium
is used.
WARNING!
Risk of slipping due to fluid in the operation and provisioning
area!
– Wear non-slip, chemically resistant shoes when working.
– Place product containers in a tank to prevent a slipping hazard
caused by leaking fluids.
ENVIRONMENT!
Immediately soak up any leaking liquids with a suitable binding agent
and dispose of properly.
2
3
on the operation screen.
144
4
Ä Chapter