Ecolab EcoAdd Series Operating Instructions Manual page 292

Control / Software
1. [Call up the main menu] :
2. [Operating mode] - [Timer] .
3.
[Click Next]
ð Screen change to the selection of the timer interval (Seven-day programme)
4. [Select Seven-day programme] .
ð Screen change to the selection: 'Timer' - [Seven-day programme]
5. Select Timer (up to seven different Seven-day programmes are possible).
ð Screen change to the setting for 'Timer 1' : 'Switching point'
6.
Press the
ð The screen switches back to the overview: [Operating mode] .
7. Use the scrollbar to set the time / hours.
8. Select time / minutes.
9. Use the scrollbar to set the time / minutes.
10. Press the button
ð Screen change for the setting: 'ON duration'
11. Use the scrollbar to set the minutes.
12. Select seconds.
13. Use the scrollbar to set the seconds.
14. Press the button
ð Screen change for the setting: 'Capacity'
15. 'Set the Capacity in L' in the place before the decimal point using the scrollbar.
16. Select the field for entering the value after the decimal point.
ð The colour changes to dark blue, which indicates that the field is ready for input.
17. 'Set the Capacity in L' in the place after the decimal point using the scrollbar.
18. Press the button
ð Screen change for the setting: 'Weekday'
19. 'Select weekdays' .
ð A check mark is set in the selection field.
20. Press the
mode' .
21. By pressing the
22. By pressing the
417102276 Rev. 5-02.2020
Ä Chapter 7.7 'Main menu' on page 73
to save the setting.
button to close the Seven-day programme without saving.
Next.
Next.
Next.
button to save the settings and return to the selection: 'Operating
button, you can return to the [main menu].
button, you can return to the [operating display].
90