Further Safety Settings - Ecolab EcoAdd Series Operating Instructions Manual

Security
2.9

Further safety settings

CAUTION!
When the pump is first started, NO ACCESS CODE is activated!
To exclude the possibility of the pump being used improperly and / or of the
system parameters being adjusted inadvertently, the pump software must
be protected by the integrated multi-stage [access code] .
During the initial configuration of the pump, we strongly recommend
enabling the [access code] and make the set passwords only available to
Ä Chapter 7.10.4 'Access code' on page 97
authorised persons:
Setting the access code also protects the pump against unauthorised
access via a smartphone connected via Bluetooth. An unprotected
pump can be accessed without restriction via the EcoAPP !
If an access code has been defined on the pump, the pump will only be
visible in the EcoAPP once the correct access code of the pump has been
entered in the EcoAPP settings.
29 417102276 Rev. 5-02.2020