Set Or Reset The Pump Capacity In L; Changing A Container - Empty Signal - Ecolab EcoAdd Series Operating Instructions Manual

Operation
9.3

Set or reset the pump capacity in L

The following screens show example displays for a pump with capacity of
11 l/h. Specifications and information shown will differ for other pump sizes.
Fig. 84: Switch the pump capacity in L during ongoing operation
Set or reset the pump capacity in L:
1. Press the 'Capacity in L' .
2. This step can be skipped if there is no password query here.
ð The screen switches to the setting for 'Capacity in L' .
3. 'Set Capacity in L' in the place before the decimal point using the scrollbar.
4. Select the field for entering the value after the decimal point.
ð The background field colour changes to dark blue, which indicates that the field is
ready for input.
5. 'Set Capacity in L' in the place after the decimal point using the scrollbar.
6. [Press the]
ð Settings are saved and the pump switches back to the operation screen.
The operation screen contains the new 'capacity in L' .
9.4

Changing a container - Empty signal

Personnel:
Protective equipment:
417102276 Rev. 5-02.2020
2
1
To enter the setting. press and hold the displayed symbol 'Capacity in
L' for approximately 3 seconds.
If you have activated an [access code]
Ä Chapter 7.7.2 'Open the main menu with the access code
activated' on page 74.
NOTICE!
We strongly recommend setting the access code!
Ä Chapter 7.10.4 'Access code' on page 97
menu button.
n Operator
Specialist
n
n Chemical-resistant protective gloves
Protective eyewear
n
Safety shoes
n
3
, note the following:
140
4
6
5