Life Span; Safety Precautions By The Owner; Obligations Of The Operator - Ecolab EcoAdd Series Operating Instructions Manual

Security
2.4

Life span

Depending on properly conducted servicing (visual inspection, functional testing,
replacement of parts, etc.), the life span is minimum 2 years.
Subsequently, revision – and in some cases a major overhaul – by the manufacturer is
required.
2.5

Safety precautions by the owner

NOTICE!
Please note that the operator must train, instruct and monitor its operating
and maintenance personnel with regard to compliance with all necessary
safety precautions.
The frequency of inspections and control measures must be observed
and documented!
WARNING!
Requirements for system components provided by the operator
To avoid personal injury and damage to the system, it must be ensured that
the system components provided to you (pipe connections, flanges) have
been correctly installed. We recommend compensators for the transition
from plastic to stainless steel pipes in order to minimise loads during
installation and operation.
If the installation is not carried out by Ecolab Engineering GmbH Customer
Support / Service, steps must be taken to ensure that the pipe and
metering lines consist of the correct materials and meet the requirements
with regard to length and diameter.
2.5.1

Obligations of the operator

Applicable Directives
In the EEA (European Economic Area), national implementation of the
Directive (89/391/EEC) and corresponding individual directives, in particular
the Directive (2009/104/EC) concerning the minimum safety and health
requirements for the use of work equipment by workers at work, as
amended, are to be observed and adhered to.
Should you be outside the scope of the EEA (European Economic Area),
the regulations applicable to you shall always apply. Make sure, however,
that the EEA regulations do not apply to you as a result of special
agreements.
It is the responsibility of the operator to check the permissible
regulations.
417102276 Rev. 5-02.2020 22