Important Information - Otto Bock X2 Series Instructions For Use Manual

1 Important information

The functional scope of products that have been serviced or repaired by an authorised Ottobock
Service Centre since October of 2018 has been extended.
Extended functional scope:
• Switching to pre-configured MyModes and changing the prosthesis settings by using the
remote control or an app for smartphones (4X441 Cockpit) (see Page 75, see Page 84). If the
joint bears the marking "DUAL", the remote control cannot be used anymore (see next sec­
tion).
• Possibility of using an intentional stance function (see Page 80)
• Displays of the current battery level without additional devices (see Page 74)
• Deactivation of feedback and vibration signals (mute mode – see Page 87)
• Stance, sitting, and stairs function can be switched off (see Page 84)
• Bluetooth function can be switched off (see Page 86)
INFORMATION
Remote control function only possible with version 1.0.0.6 or above
Please note that you can only use this and/or the updated knee joint with the 4X350-X3 remote
control in version 1.0.0.6 or higher.
Therefore, check the version of the remote control as follows:
With the remote control switched on, use the
►
settings and confirm with the
► Use the and
► Use the and
appears than 1.0.0.6, the remote control must be updated by an authorised Ottobock Ser­
vice Centre.
The function of the remote control with this or the updated knee joint is only pos­
sible with version 1.0.0.6 or higher.
INFORMATION
Adjustment of the knee joint possible only with X-Soft 4X1 version 1.8 and higher
Please note that you need X-Soft 4X1 version 1.8 or higher in order to adjust this knee joint or
the updated one. If X-Soft version 1.0 or higher is available, it can be updated (Alignment)
60
key.
keys to select the menu option Info and confirm this with the key.
keys to select the RC version: 1.0.0.4 menu option. If an older version
keys to select the menu option RC
and