TANDBERG Codec C Series Api Manual page 94

TANDBERG Codec C60 and Codec C40
Contents Contents Introduction Introduction
The Audio status,
cont...
xStatus Audio Output LocalOutput [1..n] Channels
States if the local output channels are mixed into into a mono signal (1) or stereo signal (2).
You can run the command xStatus Audio Output LocalOutput to find the identity of the output.
Value space of the result returned:
<1..2>
Example:
xStatus Audio Output LocalOutput 4 Channels
*s Audio Output LocalOutput 4 Channels: "1"
** end
xStatus Audio Output LocalOutput [1..n] Connector
Lists the connectors that are attached to the local output.
You can run the command xStatus Audio Output LocalOutput to find the identity of the output.
Value space of the result returned:
<Line.1/Line.2/HDMI.1>
Example:
xStatus Audio Output LocalOutput 4 Connector
*s Audio Output LocalOutput 4 Connector: "Line.1"
** end
xStatus Audio Output LocalOutput [1..n] Input [1..n] Gain
Shows the gain (dB) on the input, when it is connected to the local output. Range from -54 dB to 15 dB,
where -54 dB equals Off.
You can run the command xStatus Audio Output LocalOutput to find the identity of the output and input.
Value space of the result returned:
<-54..15>
Example:
xStatus Audio Output LocalOutput 4 Input 2 Gain
*s Audio Output LocalOutput 4 Input 2 Gain: 0
** end
D14642.02—MAY 2010
About the API About the API xConfiguration xConfiguration
xStatus
xCommand xCommand xStatus xStatus
The Audio status,
cont...
xStatus Audio Output RemoteOutput [1..n] CallId
Shows the CallId for the remote audio output.
You can run the command xStatus Audio Output RemoteOutput to find the identity of the output.
Value space of the result returned:
<0..65534>
Example:
xStatus Audio Output RemoteOutput 9 CallId
*s Audio Output RemoteOutput 9 CallId: 28
** end
xStatus Audio Output RemoteOutput [1..n] Input [1..n] Gain
Shows the gain (dB) on the input, when input is connected to the remote output. Range from -54 dB to 15
dB, where -54 dB equals Off.
You can run the command xStatus Audio Output RemoteOutput to find the identity of the output and
input.
Value space of the result returned:
<-54..15>
Example:
xStatus Audio Output RemoteOutput 9 Input 1 Gain
*s Audio Output RemoteOutput 9 Input 1 Gain: 0
** end
xStatus Audio Module [1..n] Type
Shows the audio module type. If the module type is DigitalNAM (Digital Natural Audio Module) you can
also read the SoftwareId and HardwareId.
Value space of the result returned:
<DigitalNAM/Unknown>
Example:
xStatus Audio Module 1 Type
*s Audio Module 1 Type: DigitalNAM
** end
94
API Guide
Appendices Appendices Contact us Contact us
www.tandberg.com