TANDBERG Codec C Series Api Manual page 88

TANDBERG Codec C60 and Codec C40
Contents Contents Introduction Introduction
The Video commands,
cont...
xCommand Video Layout UnAssign
NOTE: This command is not supported on Codec C40.
Remove the defined video layout, and go back to default.
CallId: A unique identifier for the call. The CallID is returned when the xCommand Dial command is run.
During the call you can run the xStatus Call command to see the CallId.
OutputId: A unique identifier for the local output, which was created when the xCommand Audio
LocalOutput Add command was issued.
Parameters:
CallId(r): <0..65534>
OutputId(r): <0..65534>
Example:
xCommand Video Layout UnAssign CallId: 1 OutputId: 1
*r VideoLayoutUnassignResult (status=OK):
** end
xCommand Video Layout UnAssignLocalOutput
NOTE: This command is not supported on Codec C40.
Remove the defined video layout, and go back to default.
OutputId: A unique identifier for the local output, which was created when the xCommand Audio
LocalOutput Add command was issued.
LayoutId: A unique identifier for the layout, which was created when the xCommand Video Layout Add
command was issued.
Parameters:
OutputId(r): <0..65534>
LayoutId(r): <1..2147483647>
Example:
xCommand Video Layout UnAssignLocalOutput OutputId:1 LayoutId:2
OK
*r VideoLayoutUnAssignLocalOutputResult (status=OK):
** end
D14642.02—MAY 2010
About the API About the API xConfiguration xConfiguration
xCommand
xCommand xCommand xStatus xStatus
The Video commands,
cont...
xCommand Video Layout UnAssignCall
NOTE: This command is not supported on Codec C40.
Remove the defined video layout, and go back to default.
CallId: A unique identifier for the call. The CallID is returned when the xCommand Dial command is run.
During the call you can run the xStatus Call command to see the CallId.
LayoutId: A unique identifier for the layout, which was created when the xCommand Video Layout Add
command was issued.
Parameters:
CallId(r): <0..65534>
LayoutId(r): <1..2147483647>
Example:
xCommand Video Layout UnAssignCall Callid:1 LayoutId:2
OK
*r VideoLayoutUnAssignCallResult (status=OK):
** end
xCommand Video Layout UnAssignPresentation
NOTE: This command is not supported on Codec C40.
Remove the defined video layout, and go back to default.
LayoutId: A unique identifier for the layout, which was created when the xCommand Video Layout Add
command was issued.
Parameters:
LayoutId(r): <1..2147483647>
Example:
xCommand Video Layout UnAssignPresentation LayoutId:2
OK
*r VideoLayoutUnAssignPresentationResult (status=OK):
** end
88
API Guide
Appendices Appendices Contact us Contact us
www.tandberg.com