TANDBERG Codec C Series Api Manual page 77

TANDBERG Codec C60 and Codec C40
Contents Contents Introduction Introduction
The Provisioning commands
xCommand Provisioning StartUpgrade
The codec software can be upgraded from the provisioning server. When starting the upgrade the
software is automatically downloaded and installed. A reboot of the codec is required to complete the
software upgrade.
AutoComplete On: The software upgrade is automatically completed, with a reboot of the codec.
AutoComplete Off: The software upgrade is not completed, and must be completed by running the
xCommand Provisioning CompleteUpgrade command.
Parameters:
AutoComplete: <On/Off>
Example:
xCommand Provisioning StartUpgrade AutoComplete:On
*r StartUpgradeResult (status=OK):
** end
xCommand Provisioning CompleteUpgrade
Completes the software upgrade. This will reboot the codec. NOTE! This command is required if the
xCommand Provisioning StartUpgrade has been run with the AutoComplete set to Off.
Parameters:
None
Example:
xCommand Provisioning CompleteUpgrade
*r CompleteUpgradeResult (status=OK):
** end
xCommand Provisioning CancelUpgrade
Cancel a software update in progress.
Parameters:
None
Example:
xCommand Provisioning CancelUpgrade
*r CancelUpgradeResult (status=OK):
** end
D14642.02—MAY 2010
About the API About the API xConfiguration xConfiguration
xCommand
xCommand xCommand xStatus xStatus
The SString Send command
xCommand SStringSend
Send data to the far end, e.g. for control systems. Uses the H.224 data channel (UDP).
Message: Enter the message to be sent to the far end.
CallId: The CallID is returned when the xCommand Dial command is run. During the call you can run the
xStatus Call command to see the CallId.
Parameters:
Message(r): <S: 1, 256>
CallId: <0..65534>
Example:
xCommand SStringSend CallId:4 Message:"This is a test"
*r SStringSendResult (status=OK):
** end
77
API Guide
Appendices Appendices Contact us Contact us
www.tandberg.com