TANDBERG Codec C Series Api Manual page 18

TANDBERG Codec C60 and Codec C40
Contents Contents Introduction Introduction
About xCommand
xCommand type commands instructs the system to perform an
action. xCommand type commands are supplied by the user.
To get an overview of the supported xCommand type commands,
type ? or help after the xCommand:
•
xCommand ?
•
xCommand help
To get an overview of all supported xCommand commands with
the corresponding value space, enter ??
•
xCommand ??
When you type a command and ? or help
parameters will show. Required parameters are identified by an (r)
behind the parameter name.
D14642.02—MAY 2010
About the API
About the API About the API
xCommand ?
– User Commands –
Audio
Boot
Call
CallLog
CamCtrlPip
Camera
after the xCommand:
OK
a list of the available
xCommand ??
*h xCommand Audio Microphones Mute
*h xCommand Audio Microphones Unmute
*h xCommand Audio Sound Play
Sound(r): <Busy/CallWaiting/Dial/KeyTone/Ringing/SpecialInfo/TelephoneCall/VideoCall>
Loop: <On/Off>
*h xCommand Audio Sound Stop
*h xCommand Audio Vumeter Start
ConnectorType(r): <HDMI/Line/Microphone>
ConnectorId(r): <1..8>
*h xCommand Audio Vumeter Stop
ConnectorType(r): <HDMI/Line/Microphone>
ConnectorId(r): <1..8>
*h xCommand Audio Setup Clear
.
.
.
OK
xConfiguration xConfiguration xCommand xCommand
Dial
DTMFSend
Experimental
FarEndControl
GPIO
HTTPFeedback
18
xStatus xStatus Appendices Appendices
Key SStringSend
Message Standby
Phonebook SystemUnit
Presentation TStringSend
Preset Video
Provisioning
API Guide
Contact us Contact us
www.tandberg.com