TANDBERG Codec C Series Api Manual page 68

TANDBERG Codec C60 and Codec C40
Contents Contents Introduction Introduction
The Far End Control commands
xCommand FarEndControl Camera Move
Move the far end camera (the remote camera). NOTE! The far end camera will move in the specified
direction until the stop command (ref: xCommand FarEndControl Camera Stop) is issued.
CallId: The CallID is returned when the xCommand Dial command is run. During the call you can run the
xStatus Call command to see the CallId.
Value: Select the action for how to move the camera.
Parameters:
CallId(r): <0..65534>
Value(r): <Left/Right/Up/Down/ZoomIn/ZoomOut>
Example:
xCommand FarEndControl Camera Move CallId:3 Value:left
*r FECCMoveResult (status=OK):
** end
xCommand FarEndControl Camera Stop
Stop the far end camera after the xCommand FarEndControl Camera Move has been issued.
CallId: The CallID is returned when the xCommand Dial command is run. During the call you can run the
xStatus Call command to see the CallId.
Parameters:
CallId(r): <0..65534>
Example:
xCommand FarEndControl Camera Stop CallId:3
*r FECCMoveResult (status=OK):
** end
D14642.02—MAY 2010
About the API About the API xConfiguration xConfiguration
xCommand
xCommand xCommand xStatus xStatus
The Far End Control commands,
xCommand FarEndControl Preset Activate
Move the far end camera to a camera preset position.
CallId: The CallID is returned when the xCommand Dial command is run. During the call you can run the
xStatus Call command to see the CallId.
PresetId: The PresetId for far end control must be retrieved from the far end codec.
Parameters:
CallId(r): <0..65534>
PresetId(r): <1..15>
Example:
xCommand FarEndControl Preset Activate CallId:3 PresetId:1
*r FECCPresetActivateResult (status=OK):
** end
xCommand FarEndControl Preset Store
Store the far end camera position to a camera preset.
CallId: The CallID is returned when the xCommand Dial command is run. During the call you can run the
xStatus Call command to see the CallId.
PresetId: The PresetId for far end control must be retrieved from the far end codec.
Parameters:
CallId(r): <0..65534>
PresetId(r): <0..15>
Example:
xCommand FarEndControl Preset Store CallId:3 PresetId:1
*r FECCPresetStoreResult (status=OK):
** end
68
Appendices Appendices
cont...
www.tandberg.com
API Guide
Contact us Contact us