TANDBERG Codec C Series Api Manual page 44

TANDBERG Codec C60 and Codec C40
Contents Contents Introduction Introduction
The SerialPort settings
xConfiguration SerialPort BaudRate
Specify the baud rate (data transmission rate, bits per second) for the COM 1 port on the codec. The
default value is 38400.
Connection parameters for the COM port: Data bits: 8 Parity: None Stop bits: 1 Flow control: None.
Value space: <9600/19200/38400/57600/115200>
Range: Select a baud rate from the list of baud rates (bps).
Example: xConfiguration SerialPort BaudRate: 38400
xConfiguration SerialPort LoginRequired
The Serial Login setting determines whether or not there should be a login when connecting to the COM 1
port at the codec.
Value space: <On/Off>
On: Login is required when connecting to the codec through COM port.
Off: The user can access the codec through COM port without any login.
Example: xConfiguration SerialPort LoginRequired: On
D14642.02—MAY 2010
xConfiguration
About the API About the API xConfiguration xConfiguration xCommand xCommand xStatus xStatus
The SIP settings
xConfiguration SIP Profile [1..1] Authentication [1..1] LoginName
This is the user name part of the credentials used to authenticate towards the SIP proxy.
Value space: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example: xConfiguration SIP Profile 1 Authentication 1 LoginName: ""
xConfiguration SIP Profile [1..1] Authentication [1..1] Password
This is the password part of the credentials used to authenticate towards the SIP proxy.
Value space: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example: xConfiguration SIP Profile 1 Authentication 1 Password:
xConfiguration SIP Profile [1..1] DefaultTransport
Select the transport protocol to be used over the LAN.
Value space: <UDP/TCP/TLS/Auto>
UDP: The system will always use UDP as the default transport method.
TCP: The system will always use TCP as the default transport method.
TLS: The system will always use TLS as the default transport method. For TLS connections a SIP
CA-list can be uploaded using the web interface. If no such CA-list is available on the system then
anonymous Diffie Hellman will be used.
Auto: The system will try to connect using transport protocols in the following order: TLS, TCP, UDP.
Example: xConfiguration SIP Profile 1 DefaultTransport: Auto
xConfiguration SIP Profile [1..1] Outbound
The client initiated connections mechanism for firewall traversal, connection reuse and redundancy. The
current version supports http://tools.ietf.org/html/draft-ietf-sip-outbound-20.
Value space: <On/Off>
On: Set up multiple outbound connections to servers in the Proxy Address list.
Off: Connect to the single proxy configured first in Proxy Address list.
Example: xConfiguration SIP Profile 1 Outbound: Off
44
API Guide
Appendices Appendices Contact us Contact us
www.tandberg.com