TANDBERG Codec C Series Api Manual page 63

TANDBERG Codec C60 and Codec C40
Contents Contents Introduction Introduction
The Boot command
xCommand Boot
Reboot system.
Parameters:
No paramters.
Example:
xCommand Boot
*r BootResult (status=OK):
** endOK
CUIL reboot request, restarting
Connection closed by foreign host.
The Call commands
xCommand Call Accept
Accept an incoming call. If no CallId is specified, all incoming calls will be accepted. The CallID is returned
when the xCommand Dial command is run. During the call you can run the xStatus Call command to see
the CallId.
Parameters:
CallId: <0..65534>
Example:
xCommand Call Accept CallId:19
OK
*r CallAcceptResult (status=OK):
** end
D14642.02—MAY 2010
About the API About the API xConfiguration xConfiguration
xCommand
xCommand xCommand xStatus xStatus
The Call commands,
cont...
xCommand Call Reject
Reject incoming call. If no call id is specified, all incoming calls will be rejected. The CallID is returned when
the xCommand Dial command is run. During the call you can run the xStatus Call command to see the
CallId.
Parameters:
CallId: <0..65534>
Example:
xCommand Call Reject CallId:20
OK
*r CallRejectResult (status=OK):
** end
xCommand Call Disconnect
Disconnect a call. The CallID is returned when the xCommand Dial command is run. During the call you
can run the xStatus Call command to see the CallId.
Parameters:
CallId(r): <0..65534>
Example:
xCommand Call Disconnect CallId:17
OK
*r DisconnectCallResult (status=OK):
** end
xCommand Call DisconnectAll
Disconnect all active calls.
Parameters:
No paramters.
Example:
xCommand Call DisconnectAll
OK
*r DisconnectAllResult (status=OK):
** end
63
API Guide
Appendices Appendices Contact us Contact us
www.tandberg.com