TANDBERG Codec C Series Api Manual page 24

TANDBERG Codec C60 and Codec C40
Contents Contents Introduction Introduction
About xPreferences
The xPreferences command is used to set various preferences for
the RS-232/Telnet/SSH sessions.
Each session can define preferences individually.
IMPORTANT! This command has various settings to define the
formatting of the XACLI output. It is therefore important to define
settings to match the parser used on the control system. XACLI
is designed to make parsing of data from the TANDBERG Codec
C–Series very simple.
To get an overview of the supported xPreferences commands and
their value space, type ? or help after the xPreferences:
•
xPreferences ?
•
xPreferences help
The xPreferences output modes
• Terminal: Line based XACLI output for use with line based
control systems
• XML: Pure XML output for use with control systems that
understand XML. NOTE! This mode is to be considered
experimental in version 1 of the software. Its format WILL
change in next version.
D14642.02—MAY 2010
About the API
About the API About the API xConfiguration xConfiguration
xPreferences ?
xpreferences usage:
xpreferences outputmode <terminal/xml>
OK
xCommand xCommand xStatus xStatus
24
API Guide
Appendices Appendices Contact us Contact us
www.tandberg.com