TANDBERG Codec C Series Api Manual page 92

TANDBERG Codec C60 and Codec C40
Contents Contents Introduction Introduction
The Audio status,
cont...
xStatus Audio Microphones Mute
Shows the microphones mute mode.
Value space of the result returned:
<On/Off>
Example:
xStatus Audio Microphones Mute
*s Audio Microphones Mute: Off
** end
xStatus Audio Volume
Shows the volume level (dB) of the loudspeaker output.
Value space of the result returned:
<0..100>
Example:
xStatus Audio Volume
*s Audio Volume: 70
** end
xStatus Audio Input LocalInput [1..n] Name
Shows the name of the local input. A local input is a mix of input connectors. You can run the command
xStatus Audio Input LocalInput to find the identity of the input.
Value space of the result returned:
<S: 0, 255>
Example:
xStatus Audio Input LocalInput 1 Name
*s Audio Input LocalInput 1 Name: "Microphone"
** end
D14642.02—MAY 2010
About the API About the API xConfiguration xConfiguration
xStatus
xCommand xCommand xStatus xStatus
The Audio status,
cont...
xStatus Audio Input LocalInput [1..n] MixerMode
Shows how the local input connectors have been mixed together. You can run the command xStatus
Audio Input LocalInput to find the identity of the input.
Auto: The microphone with the strongest speaker is active and the others are strongly attenuated.
Fixed: The input connector signals are mixed together with equal gains.
GainShared: The microphones are given a normalized gain factor relative to the strongest speaker before
being mixed together.
Value space of the result returned:
<Auto/Fixed/GainShared>
Example:
xStatus Audio Input LocalInput 1 MixerMode
*s Audio Input LocalInput 1 MixerMode: "Auto"
** end
xStatus Audio Input LocalInput [1..n] Mute
Shows the mute mode for the local inputs A local input is a mix of input connectors.
You can run the command xStatus Audio Input LocalInput to find the identity of the input.
Value space of the result returned:
<On/Off>
Example:
xStatus Audio Input LocalInput 1 Mute
*s Audio Input LocalInput 1 Mute: "Off"
** end
xStatus Audio Input LocalInput [1..n] Channels
States if the local input channels are mixed into into a mono signal (1) or stereo signal (2).
You can run the command xStatus Audio Input LocalInput to find the identity of the input.
Value space of the result returned:
<1..2>
Example:
xStatus Audio Input LocalInput 1 Channels
*s Audio Input LocalInput 1 Channels: 1
** end
92
API Guide
Appendices Appendices Contact us Contact us
www.tandberg.com