TANDBERG Codec C Series Api Manual page 62

TANDBERG Codec C60 and Codec C40
Contents Contents Introduction Introduction
The Audio commands,
cont...
xCommand Audio RemoteOutput DisconnectInput
Disconnect a local or remote input from a remote output with their IDs as parameters..
OutputId: A unique identifier for the local output.
InputId: A unique identifier for the local or remote input.
Parameters:
OutputId(r): <0..65534>
InputId(r): <0..65534>
Example:
xCommand Audio RemoteOutput DisconnectInput OutputId:10 InputId:8
OK
*r AudioRemoteOutputGroupDisconnectInputResult (status=OK):
** end
xCommand Audio Setup Clear
Remove all local inputs and local outputs.
Parameters:
No parameters.
Example:
xCommand Audio Setup Clear
*r AudioSetupClearResult (status=OK):
** end
xCommand Audio Sound Play
Play the specified audio sound.
Parameters:
Sound(r): <Busy/CallWaiting/Dial/KeyTone/Ringing/SpecialInfo/TelephoneCall/VideoCall>
Loop: <On/Off>
Example:
xCommand Audio Sound Play Sound: Ringing
*r AudioSoundPlayResult (status=OK):
** end
D14642.02—MAY 2010
About the API About the API xConfiguration xConfiguration
xCommand
xCommand xCommand xStatus xStatus
The Audio commands,
cont...
xCommand Audio Sound Stop
Stop playing audio sound.
Parameters:
No paramters.
Example:
xCommand Audio Sound Stop
*r AudioSoundStopResult (status=OK):
** end
xCommand Audio Vumeter Start
Start collecting VU meter information for connector given by type and ID.
Parameters:
ConnectorType(r): <HDMI/Line/Microphone>
ConnectorId(r): <1..8>
Example:
xCommand Audio Vumeter Start ConnectorType: Microphone ConnectorId: 1
*r AudioVumeterStartResult (status=OK):
** end
xCommand Audio Vumeter Stop
Stop collecting VU meter information for connector given by type and ID.
Parameters:
ConnectorType(r): <HDMI/Line/Microphone>
ConnectorId(r): <1..8>
Example:
xCommand Audio Vumeter Stop ConnectorType: Microphone ConnectorId: 1
*r AudioVumeterStopResult (status=OK):
** end
62
API Guide
Appendices Appendices Contact us Contact us
www.tandberg.com