Ma 8-01 - Sw In/Out - Switching Input And Switching Output; Figure 5.8: Ma 8-01 - Pin Assignment Sw In/Out - Leuze electronic BCL 8 Series Manual

5.3.2

MA 8-01 - SW IN/OUT - switching input and switching output

SWIN
4
FE
5
3
GND
SW IN/OUT
M12 socket
(A-coded)

Figure 5.8: MA 8-01 - Pin assignment SW IN/OUT

Attention!
Protection class IP 67 is achieved only if the connectors and caps are screwed into place!
Notice!
The switching input/switching output are programmed via the parameters in the BCLconfig
configuration software. For more information see chapter 10.6 and chapter 10.8, from
page 50 onwards.
Attention!
If you use a sensor with a standard M12 connector, then please note the following:
Use only sensors on which the switching output does not lie on pin 2 or sensor cables
on which pin 2 is not assigned. Otherwise, the switching output is not protected against
feedback on the switching input. If the inverted sensor output lies on pin 2, erroneous behav-
iour of the switching output will result.
Leuze electronic
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
SW IN/OUT(5-pin socket, A-coded)
Pin
VOUT
1
1
2 SWOUT Switching output
2
3
SWOUT
4
5
Thread
Accessories / order codes
Name
Voltage supply for sensors
VOUT
(VOUT identical to VIN at PWR IN)
GND GND for the sensors
SWIN Switching input
FE Functional earth
FE Functional earth (housing)
BCL 8
Remark
25