Commissioning; Measures To Be Performed Prior To The Initial Commissioning; Function Test - Leuze electronic BCL 8 Series Manual

Commissioning

7 Commissioning
Attention Laser Radiation!
Follow the safety notices in chapter 2.3 on page 6!
7.1

Measures to be performed prior to the initial commissioning

Before commissioning, familiarise yourself with the operation and configuration of the
device(s)!
Before connecting the supply voltage, recheck all connections and ensure that they have
been properly made.
7.2

Function Test

"Power On" test
After connecting the operating voltage, the BCL 8 performs an automatic "Power On" func-
tion test. Afterward, the green status LED on the top side of the BCL 8 lights up. Only then
are any saved customer-specific settings active.
Interface
Proper function of the interface can be tested easiest in service operation using the service
interface with the "BCLConfig" programming software and a notebook computer.
"Online commands"
Using the "Online" commands, important device functions can be checked, e.g. proper func-
tioning of the laser.
Problems
Should problems occur during device commissioning, refer first to chapter 8.2. Should a
problem persist after checking all electrical connections and settings on the devices and
host, please contact a Leuze service office near you (see the back page of this operating
manual).
36
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
BCL 8 Leuze electronic