Figure 6.7: Switching Output Bcl 8 - Leuze electronic BCL 8 Series Manual

Installation
Switching output
The switching output connection between SW IN/OUT (pin 5) and GND (pin 3) can be acti-
vated in the scanner setup.
In the basic setting, the SW IN/OUT switching output is switched to GND (pin 3) if a code is
recognised.
Figure 6.7:
Attention!
Do not load the respective switching output of the BCL 8 with more than 20mA at
+5 ... 30VDC!
Notice!
You can configure the switching input/output according to your needs using the supplied
BCLConfig program.
34
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
4.75 ... 5.5 V DC
R
+ 5 ... 30 V DC
max. 20 mA !
GND
Switching output BCL 8
BCL 8
1
+ 5 V DC
Input resistance 36 k
5
L SW_IN/OUT
3
GND
BCL 8
Ω
Leuze electronic